Thermoelectric energy conversion using blue LED material  –New design guideline for high-performance thermoelectric material –

Hokkaido University (President: Toyoharu NAWA), Sungkyunkwan University (President: Chung Kyu SANG), and The National Institute of Advanced Industrial Science and Technology (Chief Director: Ryoji CHUBACHI) found that the two-dimensional electron gas confined in GaN, which is blue LED material showing high electron mobility, exhibits high thermoelectric power factor, 2-6 times greater than that of practical thermoelectric materials. Two-dimensional electron gas: Extremely thin (a few nanometers) electron accumulated layer. Recently, high performance thermoelectric materials have been reported from USA and China. However, there is no practical thermoelectric device using those thermoelectric materials. We expect that the present finding may be useful to improve thermoelectric performance of those materials. This result has been published in the following paper (open access journal). Hiromichi Ohta*, Sung Wng Kim, Shota Kaneki, Atsushi Yamamoto, and Tamotsu Hashizume*, “High thermoelectric power factor of high-mobility two-dimensional electron gas” , Advanced Science 4, 1700696 (2017). [DOI: 10.1002/advs.201700696]

Thermoelectric conversion is an energy harvesting technology that directly converts waste heat from various sources into electricity by the Seebeck effect of thermoelectric materials with a large thermopower (S), high electrical conductivity (σ), and low thermal conductivity (κ). State-of-the-art nanostructuring techniques that significantly reduce κ have realized high performance thermoelectric materials with a figure of merit (ZT= S²∙σ∙T∙κ⁻¹) between 1.5−2. Although the power factor (PF=S²∙σ) must also be enhanced to further improve ZT, the maximum PF remains near 1.5−4 mW m⁻¹ K⁻² due to the well-known trade-off relationship between S and σ. At a maximized PF, σ is much lower than the ideal value since impurity doping suppresses the carrier mobility. We prepared a metal-oxide-semiconductor high electron mobility transistor (MOS-HEMT) structure on an AlGaN/GaN heterostructure. Applying a gate electric field to the MOS-HEMT simultaneously modulates S and σ of the high-mobility electron gas from −490 μV K⁻¹ and ~10⁻¹ S cm⁻¹ to −90 μV K⁻¹ and ~10⁴ S cm⁻¹, while maintaining a high carrier mobility (~1500 cm² V⁻¹ s⁻¹). The maximized PF of the high-mobility electron gas is ~9 mW m⁻¹ K⁻², which is a two- to six-fold increase compared to state-of-the-art practical thermoelectric materials.

[1] “Method for recycling waste energy with 2D electron gas developed”, Electronics 360, November 20, 2017

[2] “Reusing waste energy with 2-D electron gas”, Science Daily, November 20, 2017

[3] “Reusing waste energy with 2-D electron gas”, Technology Breaking News, November 20, 2017

[4] “Reusing waste energy with 2-D electron gas”, EurekAlert!, November 20, 2017

[5]  “Reusing waste energy with 2-D electron gas”, Phys.org, November 20, 2017

[6] “Reusing waste energy with 2-D electron gas”, Science Newsline, November 20, 2017

[7] “Reusing waste energy with 2D electron gas”, Humanitarian News, November 20, 2017

[8] “Reusing waste energy with 2-D electron gas”, Physics News, November 20, 2017

[9] “Reusing waste energy with 2D electron gas”, EnviromentGuru, November 20, 2017

[10] “Reusing waste energy with 2-D electron gas”, The Expanding Universe, November 20, 2017

[11] “Reusing waste energy with 2-D electron gas”, 15 Minute News, November 20, 2017

[12] “Reusing waste energy with 2-D electron gas”, Parallel State, November 20, 2017

[13] “Reusing waste energy with 2-D electron gas”, My News, November 20, 2017

[14] “Reusing waste energy with 2-D electron gas”, HiTechDays, November 20, 2017

[15] “Reusing waste energy with 2-D electron gas”, News Locker, November 20, 2017

[16] “Reusing waste energy with 2-D electron gas”, telezkope, November 20, 2017

[17] “Reusing waste energy with 2-D electron gas”, Energy Daily, November 23, 2017